locksmiths.tradeLocal locksmiths, town by town

Guide

Ignition Key Won't Turn? Causes and the Steering Lock Fix

Most often the steering lock has engaged. Turn the steering wheel gently left and right while turning the key, and it should release. If not, check an automatic is in Park, try the spare key, and look at the key for wear. An auto locksmith removes a stuck ignition key from about £90, on the MLA's figures.

Illustration: a car key fob with a flip blade

Why won't my key turn in the ignition?

Work through the causes from the most common to the rarest:

  • The steering lock is on. When the wheel is turned after the engine stops, a pin locks it, and the pin holds the ignition too. This is the usual reason, and it is not a fault.
  • The gear selector is not in Park. Many automatics will not release the key unless the selector is fully in P. Move it firmly into P and try again.
  • The key is worn or bent. Years of use round off the cuts, and a key carried on a heavy keyring wears faster.
  • It is the wrong key. A spare from another car, or a copy that was cut inaccurately, may go in but not turn.
  • The ignition barrel is worn. The MLA notes that the small wafers inside an ignition can bend or break, which jams the key.
  • The steering lock has failed, which the MLA says can lock the ignition at the same time.

The last two need an auto locksmith. The first four you can usually sort out where you are.

How do you release a steering lock?

Do not force the key. Instead:

  • Put the key fully into the ignition.
  • Keep light turning pressure on the key in the normal direction.
  • At the same time, turn the steering wheel firmly one way, then the other. It will have a little play in one direction.
  • When the pin releases, the key turns. It can take a few goes.

If the front wheels are pressed against a kerb, the pin is under more load and harder to release, so try turning the wheel away from the kerb side. Once the car starts, avoid turning the wheel with the engine off when you park, and the lock will catch less hard next time.

Is it the key or the ignition barrel?

Try the spare key. If the spare turns smoothly, the original key is worn, and the answer is a new key, not a new ignition. If both keys stick, the barrel is the likely fault.

Look at the key too. Rounded cuts, a bent blade or a crack at the neck all point to the key. Do not keep using a key that catches: a key that snaps inside an ignition is a longer and dearer job than one that sticks.

A modern key also carries a transponder chip, so a new one has to be cut and then programmed to the car. An auto locksmith typically charges £100 to £250 for a replacement key cut and programmed, against £150 to £500 or more from a main dealer (StageMyCar, 2026). The car key programming guide explains that side.

What if the key turns but the car will not start?

That is a different problem. If the key turns to the start position but the engine does not crank, or cranks but will not fire, the ignition lock is doing its job. The usual causes are a flat car battery, or the immobiliser not recognising the key, often shown by a key or padlock light on the dashboard.

Try the spare key first. If the spare starts the car, the original key's chip or its programming has failed. If neither starts it and the dashboard is dim, the battery is the more likely cause, and breakdown cover is the first call.

What does an ignition repair cost?

From the MLA's published guidance on stuck ignition keys:

WorkTypical priceSource
Removing a stuck ignition keyfrom £90MLA
Ignition replacementabout £45 parts plus £70 labour, by modelMLA
Replacement key, cut and programmed£100 to £250StageMyCar, 2026
Out-of-hours surcharge£50 to £100 on topMyJobQuote

The MLA says the work can take up to an hour, that some Volkswagen group cars cost more because the job is more involved, and that a badly done repair can push the bill past £300.

An auto locksmith can usually come to the car, which saves a recovery. Give the make, model and year, say whether the key turns at all, and ask for the total including any new keys the replacement barrel needs.

Common questions

Why is my steering wheel locked and the key will not turn?

The steering lock pin has engaged, usually because the wheel moved after the engine stopped. Turn the wheel both ways while gently turning the key, and it should free.

Will breakdown cover help with an ignition that will not turn?

Often for a steering lock or a flat battery, which a patrol can sort out. A failed ignition barrel or a broken key usually needs an auto locksmith or a garage.

Does a new ignition barrel mean new keys?

Often, because the new barrel comes with its own key. An auto locksmith may be able to recode it to your existing key. Ask before the work starts.

Is it safe to keep using a key that sticks in the ignition?

Not for long. A key that catches is wearing the barrel and may snap. Get it looked at while it still turns.

Where to go from here

Auto locksmith by town

Read next

Find a locksmith near you